20/52
Installation
RE 15354-WA/04.2015, Installation and maintenance manual, Hägglunds CA 10 - CA 40,
Bosch Rexroth Mellansel AB
6.2.3 Storing during maintenance
If the motor has been used (thus the initial rust protection has been diluted/flushed)
it can be stored up to one month, without additional rust protection. After one
month it must be protected from internal rust. This can be done as follows:
• Mix anti-rust additive with the hydraulic fluid of the system.
Use 2% of Shell VSI
8235, or similar compatible to the selected fluid.
This additive gives rust protection
for up to about 3 month in uncontrolled environment or 12 months in controlled
environment.
•
If no additives are used, the motor must be turned a few revolutions once a month
to maintain an oil film.
•
If it is not possible to turn the motor, or the storage is longer than stated periods
above, the motor must be filled according to chapter
periods or in uncontrolled environment
If the motor is kept mounted on the driven shaft, any air should be bled off through
D1-D2 for vertical shaft mount, before shut down.
7
Installation
7.1 Unpacking
CAUTION
Danger from parts falling out!
If the packaging is not opened correctly, parts may fall out and damage the parts or
even cause injuries!
1
Place the packaging on a flat and solid surface.
2
Only open the packaging from the top.
3
Remove the packaging from the Hägglunds motor.
4
Check the Hägglunds motor for transport damage and completeness, see
chapter
5
Dispose of the packaging according to the environmental regulations of your
country.
