Bosch Rexroth CytroPac, Руководство по эксплуатации

Страница: 33 / 84

Assembly 33/84
CytroPac, RE 51055-B/06.17, Bosch Rexroth AG
7.3 Hydraulic supply connection
WARNING
Pressurized system!
Danger to life, risk of injury, damage to property!
▶ Before assembling the hydraulic power unit, depressurize all relevant system
components.
Exceeded nominal pressure of a component!
Danger to life, risk of injury, damage to property!
▶ Make sure that the maximum operating pressure of 240 bar is not exceeded.
▶ Dimension the hose lines according to the maximum operating pressure.
▶ Only use components, e.g. fittings, that are approved for the required operating
pressure.
▶ Make sure that only fittings with threads measured in inches are used.
NOTICE
Damage to the hydraulic power unit!
Damage to property!
▶ Make sure that the connection between the hydraulic power unit and the
machine is only realized via hose lines. Do not use any rigid pipelines.
▶ Install the hose lines without any tension stress.
The operating pressure pre-set at the factory is specified on the name plate. See
fig. 3, pos. 7.
▶ Remove the blanking plugs (colored plastic) and replace them by pressure-
resistant fittings.
▶ Observe the installation information of the fitting manufacturers to prevent any
external leakage. Bosch Rexroth recommends fittings with elastic seals.
Install the hose lines in such a way that
– kinking and tensile load at the hose is prevented during operation.
– the hose is not twisted.
– the outer layer of the hose is not subject to abrasion or impacts.
– the weight of the hose line does not lead to inadmissible loads.
Preparation
Hose lines