Bosch rexroth Automax 100, Руководство по эксплуатации

Страница: 37 / 102

About this product | Automax 100 | Extension module TS-AC E2-M3-1X 31/94
Bosch Rexroth AG | 05.2021 | DOK-SUPPL*-TS-AC E2-M3-ITRS-EN-P
Local diagnostics and status indicators
Local diagnostics and status indicators
Local diagnostics and status indicators
Des. Color Meaning Status Description
D Red/
yellow/
green Local bus communication diagnosis
Power down Off Participants in (power) reset.
Not connected Red, flashing Participant working but there is no connection to upstream participant.
Reset Red ON Application reset
Participant working but there is still a connection to upstream participant,
application in reset.
Ready Yellow ON Participant working, there is a connection to upstream participant, participant
has not recognized valid cycle after power on.
Connected Yellow,
flashing Valid data cycles recognized but participant not (yet) part of current
configuration.
Device application
not active Green/yellow
alternating Valid data cycles are recognized.
Output data set to valid by master application, but input data not set to valid
by slave application.
Active Green,
flashing Participant working, communication within the station is OK.
Input data not read by master application. (For example, connection to the
controller has not yet been established.)
Run Green ON Valid data cycles are recognized. All data is valid.
UI Green U
Input
On Feed-in of digital input modules available.
Off Feed-in of digital input modules not available.
00 … 03,
10 … 13,
20 ... 23,
30 ... 33 Yellow Status of inputs On Input is set.
Off Input is not set.
5.2.7 Analog input module (-5KE1)
Module „S20-AI-4-I“ is used for receipt of analog current signals.
The information on the following pages is an excerpt from the data sheet.
Information on the data sheet can be found in chapter „
Required and supplementary
documentation “ as of page [

1 ].
Features

4 analog differential input channels for connection of current signals

Connection of sensors in 2, 3 and 4-wire circuit

Current ranges: 0 mA ... 20 mA, 4 mA ... 20 mA, ±20 mA

Simultaneous sampling of all channels

High crosstalk attenuation between channels by separated signal paths

Diagnostics and status indicators