22/60
Transport and storage
Bosch Rexroth AG
, A10VO, A10VSO Series 31, RE 92701-01-B/04.2018
6 Transport and storage
▶
Always observe the necessary ambient conditions for transport and storage, see
chapter 6.2 “Storing the axial piston unit” on page 24.
Information on unpacking can be found in chapter 7.1 “Unpacking” on page 26.
6.1 Transporting the axial piston unit
The following transportation options are available depending on weight and duration
of transport:
• Transporting by hand
• Transporting with a lifting device (eye bolt or lifting strap)
Table 6: Dimensions and weights
Size
18
28
45
71
88
100
140
Weight without through drive
kg
12.9
18
23.5
35.2
35.2
49.5
65.4
Weight with through drive
kg
14
19.3
25.1
38
38
55.4
74.4
Width
mm Dimensions vary by equipment. The values applicable
for your axial piston unit can be found in the installation
drawing (request if necessary).
Height
mm
Depth
mm
Weight may vary by equipment.
6.1.1 Transporting by hand
Axial piston units with a weight of up to 15 kg can be transported by hand for a short
time, if necessary.
CAUTIOn!
Danger from heavy loads!
Health hazard from carrying axial piston units.
▶
Use appropriate lifting, lowering and moving techniques.
▶
Wear your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶
Do not transport the axial piston unit by sensitive assembled parts
(e.g. sensors or valves).
▶
Carefully place the axial piston unit on the seating to prevent it from being
damaged.
6.1.2 Transporting with a lifting device
For transporting, the axial piston unit can be connected to a lifting device via an eye
bolt or a lifting strap.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶
For all female threads, use a stud end from the same system of units and of the
correct size.
▶
To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is indicated in the installation drawing.
▶
Make sure that the eye bolt can bear the total weight of the axial piston unit
plus 20%.
Dimensions and weights
Transporting with eye bolt
