English |
17
Bosch Power Tools
1 609 929 N15 | (9.11.07)
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
Replacing the Sanding Sheet
When attaching a new sanding sheet, remove any
dust or debris from the sanding plate
5
(e. g. with
a brush).
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
Sanding Sheets with Velcro Backing
(PSS 200 A/PSS 250 AE) (see figure A)
The sanding plate
5
is fitted with Velcro backing
for quick and easy fastening of sanding sheets
with Velcro adhesion.
Before attaching the sanding sheet
6
, free the
Velcro backing of the sanding plate
5
from any
debris by tapping against it in order to enable op-
timum adhesion.
Position the sanding sheet
6
flush alongside one
edge of the sanding plate
5
, then lay the sanding
sheet onto the sanding plate and press it against
it with a light turning motion in clockwise direc-
tion.
To remove the sanding sheet
6
, grasp it at one of
the tips and pull it off from the sanding plate
5
.
Sanding Sheets without Velcro Backing
(PSS 190 AC/PSS 200 AC/PSS 250 AE)
(see figure B)
Lightly lift and unlatch the sanding-sheet clamp
4
.
Guide the sanding sheet
6
under the opened rear
sanding-sheet clamp
4
to the stop and clamp the
sanding sheet by reinserting the sanding-sheet
clamp
4
.
Fold the sanding sheet
6
firmly around the sand-
ing plate. Guide the other end of the sanding
sheet
6
under the front sanding-sheet clamp
4
and clamp the sanding sheet by reinserting the
sanding-sheet clamp
4
.
Sanding sheets without holes, e. g. from rolls or
by the meter, can be punctured with the perfo-
rating tool
10
for use with dust extraction. For
this, press the machine with the mounted sand-
ing sheet onto the perforating tool (see figure E).
To remove the sanding sheet
6
, unlatch the sand-
ing-sheet clamp
4
and pull out the sanding sheet.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different sand-
ing sheets are available:
Grain size
For the working of all
wooden materials
40
—240
For coarse-sanding,
e. g. of rough, un-
planed beams and
boards
coarse
40, 60
For face sanding and
planing small irregu-
larities
medium 80, 100, 120
For finish and fine
sanding of hard
woods
fine
180, 240
For the working of
paint/enamel coats
or primers and fillers
40
—320
For sanding off paint
coarse
40, 60
For sanding primer
medium 80, 100, 120
For final sanding of
primers before coat-
ing
fine
180, 240, 320
OBJ_BUCH-60-002.book Page 17 Friday, November 9, 2007 1:20 PM
