Installation instructions
en
13
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
¡
Ensure that the information on the rating plate re-
garding the output and voltage complies with the
local connection conditions.
¡
The appliance corresponds to protection class 1.
You should therefore only use the appliance with a
protective earth connection.
¡
Do not connect the appliance to the power supply
during installation.
¡
Ensure that the protection against contact is guaran-
teed during installation.
¡
Only a qualified electrician may connect appliances
without a plug. They are subject to the requirements
of the local electricity provider.
¡
Do not use the appliance with an external timer or a
remote control.
¡
The appliance must only be connected using the
power cable provided.
12.5 Included in delivery
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
Name
Quantity
Gas hob
1 unit
Instructions for installation and use
1 copy
Burner
3 sets
Pan support
3 pcs
Inlet
1 pc
Worm clip
2 pcs
12.6 Checking the unit
▶
Check whether the kitchen unit worktop is strong
and level.
Worktop thickness·>16mm, width ≥550mm.
12.7 Preparing the unit
Requirement:
The unit is suitable for installation.
1. Note:
Check the technical specifications of the ap-
pliance and select the cavity dimensions corres-
ponding to the model.
Make a cut-out in the worktop, depending on the in-
stallation position.
The angle between the cut surface and the worktop
must be 90°.
2.
Ensure that the worktop has sufficient load-bearing
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
3.
Ensure that the fitted unit is still stable after the cut-
outs have been made.
4.
Remove any shavings.
12.8 Installing the appliance
▶
Lift the hob horizontally and slowly place it into the
opening in the worktop until the edge of the hob is
fully in contact with the worktop.
12.9 Connecting a non-metallic gas hose
Requirement:
The gas hose must meet the require-
ments.
1. Note:
Please read the installation instructions for the
gas hose carefully and install in strict accordance
with the regulations.
Use the connection elbow and corresponding seal
to connect the appliance to the gas hose.
2.
Connect the other end of the gas hose to the gas
valve.
3.
The connection between the gas hose and gas
pipeline must be secured by a compression nut or
pipe clamp.
4.
Perform a gas leak test.
Содержание PMD83D31NX
Страница 15: ......