The connection of the gas hob must be performed by
a qualified technician, and it must conform with the
legal provisions and connection requirements issued
by the local gas management department. The indoor
gas hose behind the gas meter and the air inlet at the
bottom of the gas hob should be connected with a
metal bellows and a special rubber hose whose length
should not exceed 1.5 m. (Please refer to the
appropriate requirements filed by the local gas
management department. You can consult and
purchase the special hose and hose clip at counters
for gas products in hardware stores).
We recommend you to use the metal bellows as the
gas connecting hose. If the other appliances are
installed under the hob such as a disinfecting cabinet,
baking oven and microwave oven etc, a gas rubber
hose must not be used for the gas connection.
Using a gas rubber hose for the gas connection
-The two ends of the gas hose are connected to the
gas hob and the indoor gas valve (the inside diameter
of the gas hose is 9.5 mm).
- When connecting the gas hose, you must insert the
gas hose until it reaches the red line on the
multi-directional air inlet, and secure it firmly in
position with a hose clip.
- After the connection is completed, please make sure
that the gas hose is not flattened, twisted or bent by
any other objects. Then smear soap suds all over the
hose connection part; and check each part of the
connection hose carefully to see if there is any
leakage.
- We recommend that you perform an airtight test for
the gas hob periodically while it is in use, or else
replace the gas hose annually.
- Do not leave the gas hose in a high temperature area
or put it contact with any high temperature section of
the gas hob.
Using metal bellows for the gas connection
- The specification of the external thread of the gas
hob's joint is 1/2”.
- The two ends of the metal bellows are connected to
the gas hob and the indoor gas valve respectively with
the mobile nuts. The connection parts are filled with
corrosion-resistant rubber-seal rings.
- A special gas valve must be set between the indoor
gas hose and the gas hob's bellows for easy operation.
After you turn off the gas hob this valve should also be
closed.
- After the connection is completed, you should use the
soap suds to check each connection part carefully to
make sure there is no leakage.
10
Installation Instructions
Please perform the tapping on the countertop
according to the tapping template (keeping to the
installation size of all the five types of products). To
ensure the proper connection of the gas hose, a
space of at least 100 mm height should be kept
available below the gas hob.
To ensure the stable placement of the gas hob, please
ensure that after the tapping, the vertical sides of the
installation site are smooth.
Follow the method shown in the illustration on the left
and clamp the four spring sheets supplied with the
product to the corresponding four installation positions
on the back shell.
After installing the spring sheets, push the entire gas
hob firmly into the cutout opening in the countertop,
until the outside rim of the gas hob is seated closely
on the countertop.
9
Installation Instructions
Countertop tapping
Connecting the gas
pipeline
Attention
！
100
150
345
±
2
4XR20
>50
665
±
2
hose clip
multi-directional
air inlet
red line
metal bellows
Содержание PED7230A Series
Страница 3: ......
