background image

4

• If the information in this manual is not followed ex-

actly, a fire or explosion may result causing prop-

erty damage, personal injury or death.

• Do not store articles on or against this appliance.
• Do not store flammable materials near this appli-

ance.

• Do not spray aerosols in the vicinity of this appli-

ance while it is in operation.

• Do not try to light the appliance.
• Do not touch any electrical switch; do not use any

phone in your building.

• Immediately call your gas supplier from a neighbour’s

phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire

department.

• Installation and service must be performed by an

authorised person.

1. Do not allow the flame to extend beyond the edge

of the cooking utensil. This instruction is based on

safety considerations.

2. Do not forget that the unit becomes hot when in

use. Common sense is important. Just because

the flame is out, does not mean parts cannot still

be hot.

3. This appliance shall not be used for space heat-

ing. This instruction is based on safety considera-

tions.

4. Be sure to disconnect the electrical supply before

disassembly of the appliance.

5. Keep the appliance area clear and free from com-

bustible materials, gasoline and other flammable

vapours and liquids.

6. This appliance  must be installed in a position

with the proper level of ventilation. Do not ob-

struct the flow of combustion and ventilation air.

7. Cabinets installed above the gas cooktop must

have a minimum clearance of 650 mm (24”).

8. The gas pressure regulator supplied with the ap-

pliance must be installed in line with the gas pipe.

(N.G. only)

13

Do’s

• Once the appliance is cold, clean it with a sponge

and soapy water. Remove any spills immediately.

This will avoid unnecessary effort later.

• Allow burners and trivets to cool down before clean-

ing them.

• The burners and trivets must be cleaned regularly to

keep them in good condition. This is done by sub-

merging them in soapy water and scrubbing them

with a non-metal brush to keep the ports and slots

free from obstructions so they give a perfect flame.

Dry the burner caps and trivets whenever wet or

damp.

• After cleaning and drying ensure that the burner

heads and caps are replaced correctly on the burner

body. Refer Fig. 6.

• The high temperatures generated by using the wok

burner may cause the stainless steel hob of your

hotplate to become discoloured over time. THIS IS

NORMAL. Clean the hob with a product suitable

for cleaning stainless steel.

• The trivets on your hob are fitted with rubber feet.

Be careful when cleaning as they may be dislodged

during cleaning, leaving the stainless steel hob un-

protected and subject to surface scratching .

Don’t

• Never use abrasive products, sharp objects, steel

scouring pads, knives, etc., to remove stubborn food

remains from the hob surface, trivets and burners.

• Do not allow acidic products such as vinegar, lemon

juice, etc., to come into contact with the hob.

Cleaning

For your safety

What to do if you

smell gas

Warnings

Safety considerations

Содержание PCL 785 FAU









Отзывы: