Bosch OBD1000, Руководство пользователя

Страница: 8 / 90

8 | User guide | OBD 1000 | en
574694 REV A | 11.2014 Bosch Automotive Service Solutions
2 . Locate and plug in data link
connector (DLC) .
NOTE: The data link connector
should be located under the
dashboard on the driverside of
the vehicle . If the data link con-
nector is not located under the
dashboard as stated, a label
describing the location of the
data link connector should be
there .
3 . Observe display toggles between
“Pocket” and “Scan” .
NOTE: For a correct reading for
diagnostic trouble codes and I/M
monitor status, ignition key must
be in the ON position and engine
does not require starting . To get
a correct reading for MIL status,
engine must be started .
4 . Start engine .
5 . Press and release key .
NOTE: If diagnostice trouble
codes (DTCs) are already being
displayed from a previous read
operation, press and hold
for 3 seconds and release .
6 . Observe a moving * on display .
NOTE: If “No Link” message
displays, cycle ignition key to the
OFF position for 10 seconds,
then back ON and repeat “Read-
ing Diagnostic Data” procedure .
7 . View codes on display .
NOTE: If
there are no codes present, the
tool will display “0 Codes” and
proceed to display MIL Status
when is pressed .
• To view codes, press and
release .
• If the code is a pending code,
pd will be displayed .
8 . View MIL status:
• Press and release .
9 . View I/M monitors that are
incomplete .
• Press and release .