Bosch NGM5058UC, Руководство по установке

Страница: 14 / 52

en-us
Conversion to LP gas
14
Flame Image Measure
Completely or mostly
yellow
Verify that the regulator is set for the correct fuel. Retest af-
ter adjustment.
Yellow tips on outer
cone
Normal for LP gas
Soft blue Normal for natural gas
Conversion to LP gas
5 Conversion to LP gas
Conversion to LP gas
Your appliance is equipped for use with natural gas on de-
livery. It can be converted to LP gas supply.
The components required for conversion to LP gas are
contained in the LP conversion kit included with this appli-
ance, or are available from Customer Service.
→
"Customer Service", Page 16
Only a qualified technician or installer is authorized to con-
vert the appliance to another gas type.
Before carrying out the conversion, turn off the electricity
and gas supply.
5.1 Converting the pressure regulator
WARNING
Turn off the electricity and gas supply before carrying out
the conversion.
Requirement: Complete the installation instructions in this
manual up to and including section
→
"Securing the cooktop to the countertop", Page 10
be-
fore starting the LP conversion.
1.
Locate the pressure regulator on the bottom right end of
the appliance.
2.
Remove the hexagon shaped conversion cap from the
regulator. Make sure not to dislodge the gasket on
the cap or the spring inside the regulator.
3.
Grasp the plastic orifice stem firmly and pull it force-
fully from the conversion cap . The stem snaps snugly
into an indent in the cap and may require a strong pull
to remove. It may be helpful to gently “rock” the plastic
stem while pulling it from the metal cap.
4.
Rotate the stem 180° ⁠.
a
Confirm that the button end of the orifice stem is away
from the conversion cap.
a
Confirm that the letters “LP” on the orifice stem are up-
side down when the conversion cap is set flat on its
head.