Bosch NEM73, Руководство по установке

Страница: 6 / 20

English 4
Installation Procedure
WARNING:
To avoid electrical shock hazard, before installing the
cooktop, switch power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
1) Seal the Cooktop with
Foam Tape
A foam tape is provided to seal the cooktop edges to the countertop. Turn cooktop
upside down and apply tape approximately 1/16” (1.6 mm) from the glass edges.
Use tape around the entire glass perimeter. Cut off excess tape where tape ends
butt.
Figure 4 - Seal the Cooktop
2) Prepare the Countertop Cut out the countertop per the dimensions shown in Table 1 Countertop Cutout
Dimensions . Always consult the countertop manufacturer for specific instruc-
tions.
Countertops made from natural (i.e. granite and marble) or SOLID SURFACE
MATERIALS, such as Surell™ and Corian®, require special cutout preparation
and installation procedures. Follow the guidelines below for preparing the cutout
for solid surfaces.
Figure 5 - Prepare the Countertop
1. Round the cutout corners according to instructions from the countertop manu-
facturer.
2. Apply heat reflective tape (such as Scotch® Aluminum Foil Tape #425 or
#427) around the cutout so that it folds over the top and side surfaces. Be
sure the tape extends beyond the outermost flange of the cooktop. All corners
should also be covered with tape.
3. Attach brackets to the burner box using washers and screws provided. Use a
wooden block underneath the countertop before tightening the bracket
screws.
4. Center cooktop in the cutout to ensure adequate clearance between the
burner box and countertop edge. (A light pencil mark along the center of front
edge and side edge of cooktop and counter will aid in the positioning of the
cooktop in the center.)
5. Trim excess aluminum tape from along the frame edges. BE CAREFUL not to
scratch the countertop.
Foam
Tape
Seal
Swivel Conduit Connector
shows location of
aluminum reflective
tape
tape top and vertical
sides of cutout