Bosch NEI-30, Быстрая установка

Страница: 11 / 20

NEI-30 | VEI-30 Dinion Infrared Imager Configuration | en 11
Bosch Security Systems, Inc. Quick Install Guide F.01U.166.250 | 1.0 | 2011.04
4 Configuration
All VEI-30 camera settings (except lens focus, focal length, and LED tilt) can be adjusted
remotely using the Configuration Tool for Imaging Devices (CTFID) software application. Refer
to the
Configuration Tool for Imaging Devices User Manual
located on the Bosch Security
Systems website (www.boschsecurity.com).
To adjust the focal length, focus, and the LED tilt, use the controls located on the access
panel on the rear of the camera housing. An access panel also contains the camera keypad
buttons that you use to interact with the camera’s on-screen display (OSD) menu. This menu
provides advanced set-up options for getting the best results under special circumstances.
4.1 Accessing the Controls
1. Unscrew the two (2) captive screws (item 1, below) of the access panel on the rear of
the camera housing.
2. Remove the sealing plug on the bottom left corner.
Figure 4.1 Rear camera housing with access panel
3. Open the access panel. Now you can adjust the focus, focal length, and LED tilt controls
(see
Figure 4.2
below).
Note: Before you make any adjustments, you may need to connect the camera to a
monitor to view the changes to the picture. See
Section 3 Connection, page 9
for details.
Refer to the complete installation manual (on CD) for details about advanced camera
setup using the keypad controls.
NOTICE!
Remember to replace the sealing plug and tighten the captive screws on the panel when you
finish the adjustments.