58300000129491_en_a.doc – 04.04.08
Seite 18 von 24
6.3
Replacing motor and belt
Tools:
►
Screwdriver Torx T20
6.3.1 Procedure
►
Open the appliance as described under “General disassembly”
►
Remove the motor transmission unit from the rubber bushing
►
From the underside of the motor transmission unit, unscrew the 4
Torx T20 screws
(1)
►
Push the motor to the centre of the transmission and remove the
belt from the motor shaft
►
Take the motor from the holder frame and replace it. If necessary,
insert new belt
►
Insert the new motor in the holder frame and slide it in the direction
of the arrow
►
Screw in the 4 Torx T20 screws
(1)
until the motor can be slid
further
►
Place the belt on the motor shaft
►
Tighten the belt by pulling the motor in the direction of the arrow
and secure the motor with the screws
(1)
Check belt tension:
It must not be possible to push the belt in further
than
7 - 10 mm
from the position shown
1
∆
= 7 – 10 mm
