Bosch MESM500W, Инструкция по эксплуатации

Страница: 16 / 150

16
en Cleaning
After using the appliance
■ Empty both containers and then place
them under the apertures for juice and
fruit pulp again.
■ Close the sealing cap and slide the
adjusting lever for the fruit pulp all the
way to the right.
■ Pour a little water (approx. 100 ml) into
the feed chute and move the switch
to ON .
■ After a short time, open the sealing cap
and slide the adjusting lever for fruit pulp
all the way to the left.
■ Let the appliance slow down and stop
completely before switching it off.
■ Move the switch to O and wait for the
appliance to come to a stop.
■ Disconnect the mains plug.
■ Clean all parts immediately after use.
Cleaning
The appliance and the individual parts used
must be thoroughly cleaned after each use.
W Risk of electric shock!
– Unplug the appliance before cleaning it.
– Never immerse the base unit in liquids
and do not clean in the dishwasher.
– Do not steam-clean the appliance.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not clean the individual parts in the
dishwasher.
Notes:
– When processing food such as carrots,
plastic parts may become discoloured.
This can be removed with a few drops of
cooking oil.
– Completely open the seal for fruit pulp.
X “Adjusting lever / seal for fruit pulp”
see page 13
In Fig.
H
you will find a summary of how to
clean the individual parts.
Dismantling the appliance
■ Rotate the lid to the marking (
,
) and
remove.
■ Remove the assembled juice drum.
■ Then dismantle the juicer screw, strainer
or sorbet insert piece and the rotating
brush one by one.
Note: If the individual parts in the juice
drum are jammed (e.g. due to remnants of
fruit), proceed as follows.
X Image sequence
I
1. Turn the juice drum over, putting a cloth
underneath.
2. On the underside carefully press on the
drive shaft of the juicer screw until it
releases.
3. Remove all individual parts.
Cleaning the base unit
■ Wipe the outside of the base unit with a
soft, damp cloth and dry off.
Cleaning additional parts
■ Clean the juice drum, rotating brush,
strainer insert pieces, sorbet insert
piece, juicer screw and pusher with
detergent solution, a soft cloth/sponge
and the brush provided or place them in
the dishwasher.
■ The brush provided is particularly
suitable for thorough cleaning of the
apertures for juice and for fruit pulp.
■ Clean the lid with detergent solution and
a soft cloth/sponge or a soft brush and
then rinse under running water.
■ Leave all parts to dry or dry them off
with a cloth.