LTC 9450 Series |
Instruction Manual
|
Camera & Lens Settings
Bosch Security Systems | October 10, 2006
EN
| 11
4. For white cameras, ensure that the alignment arrow
just above the lens is pointing in an upward
direction, as shown in FIGURE 6a. For black
cameras, ensure that the camera is aligned so the
circular hole pattern, just above the lens, is located
at the top left when viewed from the lens side of
the camera. See FIGURE 6b.
5. The camera may be rotated by twisting it from side
to side. See FIGURE 6a and 6b.
6. Tighten the two wing nuts after completing camera
positioning.
7. Lens adjustment is usually unnecessary, but if you
need to bring the lens closer to the window, loosen
the two screws on each side of the camera and
move the camera to the desired position. The
screw(s) is shown in FIGURE 6a (for white
cameras), or FIGURE 6b (for black cameras).
5.2
Lens Varifocal Range Adjustment
These models are provided with a 5-50mm varifocal
DC auto-iris lens.
1. Adjust the focal range to obtain the desired view, as
you would with any varifocal type lens.
6
CAMERA & LENS SETTINGS
6.1
Backlight Compensation, White
Balance, Line Lock, and Phase
Settings
As received, the unit will be set with the backlight
compensation off, the white balance on, and the line
lock on. See FIGURE 7a or 7b (depending on the
supplied camera) for the location of the dip switches
and the phase control. See FIGURE 8 for a detailed
view. Note that white balance applies to color cameras
only.
1.
Dip Switches:
The dip switches may be changed
from their default positions if desired. Remove the
lens connector on black cameras to access the dip
switches; see Section 6.2.
2.
Phase Control:
The phase may be adjusted as
required by using a small blade screwdriver.
Figure 7a: Location of Camera & Lens Settings for
White Cameras
Figure 7b: Location of Camera & Lens Settings for
Black Cameras
The control functions and settings described below are
shown in the same sequence as they appear in
FIGURE 8.
Phase Control
V
V -- P
P H
H A
A S
S E
E
Vertical Phase Adjustment
Default Dip Switch Settings
Color
B&W
4
L
L L
L
Line Lock
On
On
3
n
n c
c
not used
--
--
2
w
w b
b
White Balance
On
--
1
b
b ll c
c
Backlight
Compensation
Off
Off
See
FIGURE 8
See
FIGURE 8
Phase Control Opening
Lens Connector
