en
What to do in the event of a fault
30
3
What to do in the event of a fault
What to do in the event of a fault
Before you call Customer Service, use this table to check whether you can rectify the fault yourself.
--------
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
"Switching off and disconnecting the appliance" on page 18
If the temperature is too warm, check temperature again after a cou-
ple of hours.
If the temperature is too cold, check temperature again on the follow-
ing day.
Displays do not illuminate.
The mains plug has not been inserted properly.
Connect mains plug.
The fuse has been tripped.
Check the fuses.
The power has failed.
Check whether the power is on.
Display shows E....
Electronics have detected a fault.
Call Customer Service.
The alarm off button flashes and a warning signal sounds.
Press
alarm off
button. The alarm is switched off.
Refrigerator compartment, cool-fresh compartment or freezer com-
partment is open.
Close the appliance.
Ventilation openings are covered up.
Clear the ventilation openings.
Large quantities of fresh food were placed in the appliance.
Do not exceed maximum freezing capacity.
The temperature in the refrigerator compartment, cool-fresh compart-
ment or freezer compartment is too warm.
Press
alarm off
button. After the
alarm off
button is pressed, the
warmest temperature reached in the freezer compartment is dis-
played for 5 seconds. The display stops flashing.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
Start the appliance self-test.
"Appliance self-test" on page 31
When the programme has ended, the appliance switches over
to normal operation.