Bosch ITS-DX4020-G, Инструкция по установке и эксплуатации

Страница: 20 / 52

20 en | Configuration GPRS/GSM IP Communicator
F01U163066 | 01 | 2010.05 Installation and Operation Guide Bosch Security Systems, Inc.
Table 4.6 Configuration Mode (J200 Jumper Installed) LED States
4.1.4 Exit from CONFIG MODE
1. Remove the jumper plug from the CONFIG MODE jumper pins.
The ITS-DX4020-G restarts.
2. Check the status of the CELL IP LED to see if the ITS-DX4020-G can communicate with
the central station receiver.
Refer to Table 4.7 for more information.
Table 4.7 CELL IP LED Status
4.2 Use USB to Configure the ITS-DX4020-G
You can use a USB connection from a laptop or desktop PC to the ITS-DX4020-G to configure
the ITS-DX4020-G on-site.
Before you can access the USB user interface, you must install the ITS-DX4020-G.inf file on
the target PC or laptop. The ITS-DX4020-G.inf file is available on the supplied CD-ROM. You
need to install this file only once on the target PC or laptop.
If the ITS-DX4040-G CD-ROM is not available:
1. From your Internet browser, go to http://www.boschsecurity.com to open the Bosch
Web site.
2. Select the web site for your region and country.
3. In the Online Catalogs section on the left, click the Intrusion Alarm Systems link.
LED State
Condition STATUS CELL
IP
AUDIO SS1 SS2 SS3 BUS
1 No control panel authorization received. GSM Signal Strength Off
2 Installer is authorized for Configuration mode,
or authorization is not required.
GSM Signal Strength On
3 Received invalid SMS. Flash Flash Flash Flash
4 Received valid SMS authorizing configuration.
Key: = Scrolling LEDs, from left to right.
→ → →
→ → →
→ → →
→ → → → → → →
→
NOTICE!
If the LEDs indicate an invalid SMS, remove the configuration jumper and then repeat the
steps in Section 4.1.1 Enter CONFIG MODE, page 17 .
If the LEDs continue to indicate an invalid SMS, the configuration SMS might be incorrect.
Ensure that your configuration SMS contains the correct information, or use the USB
connection to configure the ITS-DX4020-G.
CELL IP LED State Status
Off The ITS-DX4020-G is not connected to the GPRS network.
Flash The ITS-DX4020-G is connected to the GPRS network, but it is not
connected to the central station receiver.
On The ITS-DX4020-G is connected to the central station receiver
through the GPRS network.