Bosch ISW-BDL1-W11PGX, Справочное руководство системы

Страница: 41 / 58

wLSN wLSN Devices | en 41
Bosch Security Systems, Inc. System Reference Guide F01U138553 | 01 | 2010.05
Testing and Enabling When Only the Low-temperature Sensor
is Required
During the Point Test, test the low-temperature sensor. Refer to
Table 5.17 for instructions.
The system announces “Point xx was tested.”
Do not connect the water sensor probe.
Table 5.17 Testing and Enabling Procedures
Figure 5.14 Enabling the Water Probe and Low-Temperature Functions
Sensor To test and enable:
Water Select one of the following methods:
–
Short the water probe pins for at least 5 sec.
Refer to Figure 5.14 .
–
Submerge the water probe in water for at least
5 sec.
Low-temperature Short the “T” pads for at least 5 sec. Refer to
Figure 5.14 .
Callout Description
1 Probes for water sensor
2 "T" pads for low-temperature sensor
1
2