Rails
en
21
12.6 Using cleaning gel for burnt-on dirt
For hard-to-remove, burnt-on dirt, you can order a
cleaning gel from our online shop, from your specialist
retailer or via our after-sales service.
1.
Follow the instructions on the cleaning product.
2.
Remove the pan supports and the burner parts.
3. ATTENTION!
On the burner parts, the controls and the aluminium
surfaces, the cleaning gel leads to damage.
▶
Only use the cleaning gel on the pan supports
and stainless steel surfaces.
Apply the cleaning gel to the burnt-on dirt.
4.
If necessary, let the dirt soak overnight.
12.7 Cleaning the stainless steel surfaces
1.
Observe the information regarding the cleaning
agents.
2.
Clean using a sponge cloth and hot soapy water in
the direction of the finish.
3.
Dry with a soft cloth.
4.
Apply a thin layer of the stainless steel cleaning
product with a soft cloth.
Tip:
You can obtain stainless steel cleaning products
from after-sales service or the online shop.
12.8 Cleaning the burners
After long use, the brass burner parts become darker
due to natural oxidation. This discolouration does not
affect their usability.
WARNING ‒ Risk of burns!
The appliance becomes hot during operation.
▶
Allow the appliance to cool down before cleaning.
1.
Carefully remove the pan support.
2.
Carefully remove the burner parts.
3.
Clean the burner parts using a scrubbing brush and
washing-up liquid.
4.
Rinse the burner parts with clean water.
5.
Ensure that the burner parts are completely dry be-
fore fitting them; otherwise, there may be ignition
problems or problems during operation.
12.9 Cleaning the electric hotplate
If the surface of the electric hotplate is dirty as a result
of long-term use, clean the surface with a few drops of
oil or standard care products.
WARNING ‒ Risk of burns!
The appliance becomes hot during operation.
▶
Allow the appliance to cool down before cleaning.
1.
Clean the electric hotplate using a scrubbing brush
and washing-up liquid.
2.
Briefly heat up the hotplate afterwards so that it
dries. Wet plates rust over time.
3. Note:
Due to the high heat effect, the metallic hot-
plate ring may discolour over time.
Rectify the discolouration by cleaning the hotplate
ring with the rough side of a sponge with washing-
up liquid or abrasive cleaning agents. When clean-
ing, ensure that the sponge does not come into
contact with the hotplate.
12.10 Cleaning the cooking zone switch
Clean the cooking zone switch after use if it is dirty or
stained.
Note:
¡
Read the information on unsuitable cleaning agents.
¡
Do not use a glass scraper.
¡
Do not use a glass ceramic cleaner.
¡
Do not remove the cooking zone switch.
1.
Clean the cooking zone switch using hot soapy wa-
ter and a soft cloth.
– Wring out the cloth well. The cloth must not be
too wet.
– Wash new sponge cloths thoroughly before use.
2.
Dry with a soft cloth.
13 Rails
To clean the rails and cooking compartment thor-
oughly, you can remove the shelf supports.
13.1 Unhooking the rails
WARNING ‒ Risk of burns!
The rails can be very hot.
▶
Never touch the rails when they are hot.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Hold the bottom of the shelf support and pull it
slightly towards the front. Pull the extension pins in
the lower section of the rails out of the mounting
openings.
