en
Installation instructions
32
1.
Replace all of the bypass nozzles in the appliance.
You can find additional information about this in the
section entitled "Removing the control panel"
→
2.
Then carry out the steps in the section entitled "Re-
placing the bypass nozzles" →
.
3.
Then carry out the steps described in the section
entitled "Installing the control panel" →
Removing the control panel
1.
Remove the pan support grids or the pan support
racks and the burner parts.
2.
If burner connection screws are present on the hob,
remove all of these.
3.
Remove the two screws (T20) at the front right and
left of the hob panel. Do not remove the plastic
parts that are located below these.
4. Note:
To ensure that no scratches are formed on
the matte glass plate, do not allow the underside of
the hob to come into contact with objects.
Hold the front section of the hob and tilt it upwards
at a maximum angle of 30°. Secure the hob with
the profile bar by placing it vertically on the front
burner mount.
5.
Remove the plastic covers from the front profiles on
the right and left. Ensure that the covers are not
damaged or scratched. Unscrew the screws (T20)
below these.
6.
Remove the two screws (M4) that are uncovered
when you remove the control knobs (T15).
