Bosch HBL53B5.0A, Инструкция по эксплуатации

Страница: 13 / 28

13
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
1.
First insert the rail into the rear socket, press it to the back
slightly (figure A),
2.
and then hook it into the front socket (figure B).
The rails fit both the left and right sides. The kinked section
must always be at the bottom.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the order in
which the panels are removed. In order to reassemble the
panels in the correct sequence, follow the number which
appears on each panel.
The oven door may open either to the left or to the right,
depending on the appliance model.
Removal and installation instructions for the door panels apply
to left and right-opening oven doors.
Removal
1.
Open the oven door.
2.
Unscrew the cover at the top of the oven door. To do this,
undo the left and right screws (fig. A). Hold the panel with
one hand.
3.
Pull the top panel up and out (fig. B).
4.
Unscrew the retaining clips on the right and left and remove
them (fig. C). Remove the middle panel.
5.
Pull the lower panel diagonally upwards and out.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is at the
top right on both panels.
1.
Insert the lower panel diagonally downwards (fig. A).
2.
Insert the centre panel.
3.
Stick the retaining clips onto the right and left-hand side of
the panel, aligning them so that the carriers are over the
screw holes, and then screw them in place (fig. B).
4.
Insert the uppermost panel and hold in place. The smooth
surface must face outwards.
5.
Put the cover back in place and screw it on.
6.
Close the oven door.
Do not use the oven again until the panels have been
correctly fitted.
% $
% $
&
% $