8
Always disconnect the
plug from the power
source before attaching or removing sand-
ing sheets.
ATTACHING SANDING SHEETS
When attaching a new sanding sheet, remove
any dust or debris from the sanding pad
4
(e. g. with a brush).
1. Unlock both sanding-sheet clamp levers
5A
and
6A and swivel them downwards (Fig. 2).
2. Insert the sanding sheet
7 under the rear
clamping bracket
5B. Ensure that the sand-
ing sheet
7 is not too short to be correctly
clamped under clamping brackets
5A and
5B. Swivel the sanding sheet clamp lever
5A back into the starting position and lock it
there (Fig. 3).
3. Place the sanding sheet taut around the
sanding pad
4. Clamp the front part of the
sanding sheet under the front clamping
bracket
6B. Ensure that the sanding sheet
7 is not too short and that it is correctly
clamped. Swivel the sanding-sheet clamp-
ing lever
6A back into the starting position
and lock it there (Fig. 4).
PUNCH PLATE
After the sanding sheet has been installed,
it will be necessary to punch holes into the
sheet using the punch plate provided with
your sander. Align sander base with punch
plate and push down on sander until punch
plate pierces the sheet. Then remove punch
plate from sander (Fig. 5)
To ensure optimum dust extraction, pay at-
tention that the punched holes in the sand-
ing sheet match with the holes in the sanding
plate.
REMOVING SANDING SHEETS
To remove the sanding sheet
7, unlock both
sanding-sheet clamp levers
5A and 6A and
pull the sanding sheet out of its holder.
Assembly
5A
6A
6B
5B
4
Fig. 2
6B
7
6A
4
Fig. 4
7
5A
5B
4
Fig. 3
13
Fig. 5
1600A00HX5 11-15 GSS20-40.indd 8
11/9/15 7:22 AM
