English |
21
Bosch Power Tools
1 609 929 U15 | (8.12.09)
c) Do not use a pneumatic tool that has a defective
On/Off switch.
A pneumatic tool that cannot be
controlled with the switch is dangerous and must be
repaired.
d)Disconnect the air supply before making any ad-
justments, changing accessories, or placing the
pneumatic tool aside.
This safety measure prevents
accidental starting of the pneumatic tool.
e)Store idle pneumatic tools out of the reach of chil-
dren. Do not allow persons unfamiliar with the
pneumatic tool or these instructions to operate
the device.
Pneumatic tools are dangerous in the
hands of untrained users.
f) Maintain the pneumatic tool with care. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect
the pneumatic tool's operation. Have damaged
parts repaired before using the pneumatic tool.
Many accidents are caused by poorly maintained
pneumatic tools.
g)Use the pneumatic tool, accessories, application
tools, etc. according to these instructions. Take in-
to consideration the working conditions and the
activities to be carried out.
Use of the pneumatic
tool for operations different from those intended
could result in hazardous situations.
5) Service
a)Have your pneumatic tool repaired only through a
qualified repair person and only using original re-
placement parts.
This will ensure that the safety of
the pneumatic tool is maintained.
Safety Warnings for Compressed-air
Nailers/Staplers
Wear safety goggles.
f
Always assume that the pneumatic tool is loaded
with fasteners.
Careless handling of the pneumatic
tool can lead to unexpected shot actuation of fasten-
ers and cause injury.
f
When working, hold the pneumatic tool in such a
manner that your head and body cannot be injured in
case of sudden kickback due to a malfunction of the
energy supply or from hard objects/locations in the
workpiece.
f
Never point the pneumatic tool at yourself or at per-
sons close by.
Unexpected actuation will expel a fas-
tener, which can lead to injury.
f
Do not actuate the pneumatic tool until firmly placed
against the workpiece.
When the pneumatic tool is not
in contact with the workpiece, the fastener can bounce
away from the fastening point and overload the pneu-
matic tool.
Do not work on ladders or scaffolds when
the actuation system “Contact actuation” is
set. In particular, do not move from one fas-
tening location to another, close boxes or
enclosures, or fasten transport-securing fix-
tures on e.g., vehicles and waggons, via scaf-
folds, stairs, ladders or ladder-like construc-
tions, such as roof battens.
With this
actuation system, a fastener will be dis-
charged each time when accidentally apply-
ing the pneumatic tool while the discharge
lock-off is pressed in. This can lead to injury.
f
Observe the conditions of the job site.
It is possible
that fasteners can burst through thin workpieces or be
deflected when working in corners or against edges,
and harm persons.
Disconnect the air supply, when the fasten-
er is jammed in the pneumatic tool.
When
the pneumatic tool is still connected to the
power supply, it can accidentally be actuated
when removing a jammed fastener.
f
Use caution when removing a jammed or stuck fas-
tener.
The system can be under tension and cause the
fastener to be shot or thrust out, while attempting to
clear the jam.
OBJ_BUCH-1037-001.book Page 21 Tuesday, December 8, 2009 1:03 PM
