English |
21
Bosch Power Tools
1 609 929 M29 | (10.9.07)
Assembly
Auxiliary Handle (see figure A)
f
Operate your machine only with the auxiliary
handle 10.
The auxiliary handle
10
can be set to any position
for a secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle
10
in
counterclockwise direction and swivel the auxil-
iary handle
10
to the desired position. Then
retighten the bottom part of the auxiliary handle
10
by turning in clockwise direction.
Adjusting the Drilling Depth (see figure A)
The required drilling depth
X
can be set with the
depth stop
11
.
Press the button for the depth stop adjustment
9
and insert the depth stop into the auxiliary han-
dle
10
.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth
X
.
The knurled surface of the depth stop
11
must
face upward.
Changing the Tool
f
Before any work on the machine itself, pull
the mains plug.
Keyless Chuck (see figure B)
The drill spindle is locked when the On/Off
switch
6
is not pressed. This makes quick, con-
venient and easy changing of the tool in the drill
chuck possible.
Open the keyless chuck
1
by turning in rotation
direction
n
, until the tool can be inserted. Insert
the tool.
Firmly tighten the collar of the keyless chuck
1
by
hand in rotation direction
o
until the locking ac-
tion (“click”) is no longer heard. This automati-
cally locks the chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direc-
tion.
Key Type Drill Chuck (see figure C)
f
Wear protective gloves when changing the
tool.
The drill chuck can become very hot dur-
ing longer work periods.
Open the key type drill chuck
13
by turning until
the tool can be inserted. Insert the tool.
Insert the chuck key
12
into the corresponding
holes of the key type drill chuck
13
and clamp the
tool uniformly.
Screwdriver Tools (see figure D)
When working with screwdriver bits
14
, a univer-
sal bit holder
15
should always be used. Use only
screwdriver bits that fit the screw head.
For driving screws, always position the “Drill-
ing/Impact Drilling” selector switch
2
to the
“Drilling” symbol.
Replacing the Drill Chuck
f
Before any work on the machine itself, pull
the mains plug.
f
For power tools without spindle lock, the
drill chuck must be replaced by an author-
ised after-sales service agent for Bosch pow-
er tools.
The drill chuck must be tightened with a
tightening torque of approx.
35–40
Nm.
Operation
Starting Operation
f
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V can
also be operated with 220 V.
Reversing the Rotational Direction
(see figures E–F)
f
Actuate the rotational direction switch 7 on-
ly when the machine is at a standstill.
The rotational direction switch
7
is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch
6
actuated.
OBJ_BUCH-486-001.book Page 21 Monday, September 10, 2007 9:49 AM
