11
EURO • Printed in USA • BA 3 609 929 557 • GKS 75S/85S • GB • OSW 12/00
3 609 929 557 • TMS • 29.11.00
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed.
Before using for the first time,
ask for a practical demonstra-
tion.
If the mains cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
Wear ear protection.
Wear safety goggles.
The dust that is produced while
working can be detrimental to
health, inflammable or explosive.
Suitable safety measures are re-
quired.
Examples: Some dusts are re-
garded as carcinogenic. Use suita-
ble dust-/chip extraction and wear a
dust mask.
■
Never allow children to use the machine.
■
For long hair, wear hair protection. Work only
with closely fitting clothes.
■
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
■
Always direct the cable to the rear away from
the machine.
■
Insert the mains plug only when the machine is
switched off.
■
Before any work on the machine itself, pull the
mains plug.
■
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
■
The machine must be operated only with the
appertaining protective devices.
■
The swinging protective guard 4 must be able
to move freely and close on its own accord; it
must not be clamped whilst it is open.
■
Always use the riving knife 7.
■
For stationary use, the machine may be oper-
ated only on a sawing table with restarting pro-
tection.
■
Apply the machine to the workpiece only when
switched on.
■
Clamp the workpiece if it does not remain sta-
tionary due to its own weight.
■
When working, always guide the machine
away from the body.
■
Do not work with materials containing asbes-
tos.
■
The cutting path must be free of obstacles both
above and below.
■
The saw blade must not protrude more
than 3 mm out of the work piece.
■
Keep hands clear of the rotating saw blade. Do
not come into contact with the rotating saw
blade on the underside of the workpiece.
■
Do not allow fingers to enter the sawdust ejec-
tor 1.
■
Do not saw into nails, screws, etc.
■
Do not work overhead with the machine.
■
The saw blade and riving knife must not be-
come stuck in the cut. The saw tooth offset
must be wider and the main body of the saw
blade thinner than the thickness of the riving
knife.
■
Protect saw blades against shocks and im-
pacts.
■
Do not tilt the saw blade.
■
If the saw blade jams, switch off the machine
immediately.
■
After switching off, do not slow down the saw
blade by exerting side pressure.
■
Always switch off the machine and allow to
come to a stop before placing it down.
■
Use only sharp, flawless saw blades. Change
any cracked, bent or dull saw blades immedi-
ately.
■
Saw blades of highly alloyed, high-speed steel
must not be used.
■
Bosch is only able to ensure perfect functioning
of the machine if the original accessories in-
tended for it are used.
For Your Safety
GKS 75 S/85 S.book Seite 11 Donnerstag, 30. November 2000 2:47 14
