20
| English
2 609 932 657 | (15.10.09)
Bosch Power Tools
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
18.09.2009
Assembly
Battery Charging
f
Use only the battery chargers listed on the
accessories page.
Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note:
The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against
deep discharging by the “Electronic Cell Protec-
tion (ECP)”. When the battery is empty, the ma-
chine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
Do not continue to press the
On/Off switch after the ma-
chine has been automatically switched off.
The
battery can be damaged.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Observe the notes for disposal.
Removing the Battery
The battery
6
is equipped with two locking lev-
els that should prevent the battery from falling
out when pushing the battery unlocking button
5
unintentionally. As long as the battery is in-
serted in the power tool, it is held in position by
means of a spring.
To remove the battery
6
, press the unlocking
button
5
and pull out the battery toward the
front.
Do not exert any force.
Battery Charge-control Indication (only for
3.0 Ah battery) (see figure A)
The three green LEDs of the battery charge-con-
trol indicator
11
indicate the charge condition of
the battery
6
. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
Press button
10
to indicate the charge condi-
tion. This is also possible when the battery
6
is
removed.
When no LED lights up after pushing button
10
,
then the battery is defective and must be re-
placed.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
WARNING
LED
Capacity
Continuous lighting 3 x green
≥
2/3
Continuous lighting 2 x green
≥
1/3
Continuous lighting 1 x green
<1/3
Flashing light 1 x green
Reserve
OBJ_BUCH-565-005.book Page 20 Thursday, October 15, 2009 2:38 PM