46
| English
1 609 929 X04 | (13/7/10)
Bosch Power Tools
Bevel angle range
(see figure K)
– Pull the right fence extension
19
completely
outward. (see “Extending the Fence”,
page 45)
– Loosen the clamping lever
14
.
– Lightly tilt the tool arm leftward out of the 0°
position via handle
5
and turn knob
39
until
the desired bevel angle range is indicated.
– Tilt the tool arm via handle
5
to the right until
angle indicator
22
indicates the desired bev-
el angle.
– Hold the tool arm in this position and retight-
en the clamping lever
14
.
The clamping force of the clamping lever
must securely hold the position of the tool
arm at any bevel angle.
Standard 0° Bevel Angle
To enable simple and swift resetting of the
standard 0° bevel angle, knob
39
will engage in
the
bevel angle range.
– Tilt the tool arm from right to left over the 0°
position.
Bevel angle range
– Pull both fence extensions
19
completely
outward. (see “Extending the Fence”,
page 45)
– Loosen the clamping lever
14
.
– Lightly tilt the tool arm leftward out of the 0°
position via handle
5
and turn knob
39
until
the desired bevel angle range is indicated.
– Tilt the tool arm via handle
5
to the left or
right until angle indicator
31
or
22
indicate
the desired bevel angle.
– Hold the tool arm in this position and retight-
en the clamping lever
14
.
The clamping force of the clamping lever
must securely hold the position of the tool
arm at any bevel angle.
Standard 33.9° Bevel Angle
–
Standard angle 33.9°:
Pull adjustment knob
32
completely outward
and turn it by 90°. Now tilt the tool arm via
the handle
5
until the tool arm can be heard
to engage.
Adjusting the Handle (see figure L)
For a more convenient hand position, the handle
5
can be turned to 4 different positions.
– Loosen clamp
3
.
– Grasp and pull tongue
4
outward, then turn
handle
5
until it engages in the desired posi-
tion.
– Let go of tongue
4
again and lock clamp
3
.
Starting Operation
f
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On (see figure M)
– To
start
the machine, press the On/Off
switch
25
and keep it pressed.
Note:
For safety reasons, the On/Off switch
25
cannot be locked; it must remain pressed during
the entire operation.
The locking lever
41
will only disengage the re-
tracting blade guard
8
after pressing button
6
,
so that the tool arm can be lowered.
– For
sawing
, you must press button
6
in addi-
tion to actuating the On/Off switch.
Switching Off
– To
switch off
the machine, release the
On/Off switch
25
.
0 – 45°
45°– 0
45°+
OBJ_BUCH-1128-002.book Page 46 Tuesday, July 13, 2010 11:27 AM
