10
Mounting the Dust Collection Tube
• When blowing out bore holes, the drilling
debris is blown in the direction of the
operator. For this reason, it is
recommended that you mount the dust
collection tube
11
over the bore hole nozzle
10
.
• Place the notches
13
of the dust collection
tube
11
over the outer bayonet lock
12
of
the bore hole nozzle
10
.
• Turn the dust collection tube
11
a quarter
turn clockwise (Fig. 5).
12
13
11
10
Remove the battery before cleaning or performing maintenance on
the blower, making tool adjustments, changing attachments or
storing the blower.
This safety measure prevents the blower from being started accidentally.
FIG. 5
Operating Instructions
Protection Against
Deep Discharging
The lithium ion battery is protected against
deep discharging by the “Electronic Cell
Protection (ECP)”. When the battery is empty,
the tool is switched off by means of a
protective circuit.
Do not continue to press
the trigger switch after
the tool has been automatically switched
off.
The battery can be damaged.
Switching On and Off
To save energy, only switch the power tool on
when using it.
To switch on the power tool, press the On/Off
switch
1
to position I or II.
- Position I: Blowing light materials.
- Position II: Blowing heavy materials.
To switch off, push the On/Off switch
1
to the
stop in position “0”.
Working Advice
• This blower is intended for Household use
only.
• Always wear eye protection.
• Never blow dirt in the direction of
bystanders.
• Always hold the power tool approx. 1.2
inches (30 mm) above ground when
working.
• Do not blow hot, flammable, combustible or
explosive material.
• Do not use blower to blow dust containing
crystalline silica from bricks, cement and
other masonry products.
• During “blowing” operation, make sure that
no debris/impurities are drawn into the air
intake
4
(Fig. 1).
1619PA9788.qxp_GBL18V-71 4/11/18 10:01 AM Page 10
