Bosch FPA-1200, Информация о системе

Страница: 101 / 174

Modular fire panel Installation | en 101
Bosch Sicherheitssysteme GmbH System Information 07.2020 | 12.0 | F.01U.028.089
2
1
Figure 4.50: Detaching the screw terminal block
4.9.2 ANI 0016 A Annunciator Module
Figure 4.51: ANI 0016 A Annunciator Module
The annunciator module has 16 red and 16 yellow LEDs for displaying the operating states of
16 definable detection points.
The activation of each LED is defined using the FSP-5000-RPS programming software.
This defines which detection points will activate the LEDs in which state.
The technical data can be found in
ANI 0016 A Annunciator Module, page 150.
4.9.3 BCM‑0000‑B Battery Controller Module
The BCM-0000-B Battery Controller Module monitors the power supply of the entire panel and
regulates the temperature and time-controlled charging of up to four batteries.
The following functions are available using the keys on the module
(1) :
– The four LEDs on the module light up as a confirmation and LED test each time the key is
pressed.
– If the batteries have a voltage of between 18 V and 21 V, the battery charging procedure
can be started manually. Please note that a power supply must be available.
– The 24 V switch outputs can be reset.
The switch output is deactivated if a fault occurs.