26
en | Wiring
Remote Keypad
2017.07 | 4.0 | F.01U.258.926
Installation Guide
Bosch Sicherheitssysteme GmbH
4
Wiring
1.
Connect the shield wires to the screw terminal (
11, page 000
, step 1).
2.
Fasten the cables with cable ties (
11, page 000
, step 1 to 4).
The Remote Keypad has
–
2 CAN interfaces (CAN1/CAN2) for networking
–
2 Ethernet interfaces (ETH1/ETH2) for networking
–
2 signal inputs (IN1/IN2)
–
1 USB and 1 RS232 interface
Consider the maximum cable length of 2 m when using the USB and RS232 interfaces (see
10,
page 000
).
Notice!
You will find detailed information about the CAN and Ethernet networking of the fire panels in
the Networking Guide available for download at www.boschsecurity.com.
!
Caution!
If Ethernet networking is planned, the Remote Keypad must be grounded.
Address Setting and Configuration
1.
Assign a unique physical address to each Panel Controller and Remote Keypad by setting
the rotary switches and write it down on the label (see
13, page 000
, step 1 and 2).
2.
For configuration, set the 6-pin DIP switch (see
13, page 000
, step 3).
3.
Mark the setting on the provided label (step 4).
5
Technical Data
LCD Ddisplay / touch screen
LCD display with 320 x 240 pixels, touch screen with
127,5 mm x 170 mm active surface
Operating and display elements
22 buttons, 1 key switch, 12 LEDs, 1 Reboot button
Interfaces
CAN1, CAN2, ETH1, ETH2, USB, RS232
Signal inputs
IN1/IN2
Permissable length of CAN cable for system
networking
Lmax = 1000 m, depending on configuration, cable type and
topology
Power supply connection
DC1 (power supply), DC2 (redundant power supply)
Input voltage
12 V DC to 30 V DC, from FPA-5000/FPA-1200 or FPP‑5000
Maximum line restance of power supply
18 Ω
Maximum current consumption
–
Standby operation: 140 mA at 24 V DC
–
During an alarm: 230 mA at 24 V DC
Permissible operating temperature
-5 °C to +50 °C
Permissible storage temperature
-20 °C to +70 °C
Housing material and color
ABS plastic, light gray (similar RAL 7035)
Dimansions (H x W x D)
280 mm x 340 mm x 87 mm