7
Connecting to the water supply
A pipe or standard domestic fresh-water hose is required for the
water supply, with a minimum pressure of 1 bar (water should
flow at a rate of approximately 8 litres per minute with the tap
fully open).
If the pressure is higher than 10 bar, a pressure reducing valve
should be inserted between the appliance and the water supply.
Never connect the appliance to the mixer tap of an
unpressurized water heater. If in doubt have connections
made by a qualified technician.
Connections between the appliance and the water
supply must be able to withstand the full water pressure.
Check the ring seal with the tap fully open.
Remove the filters at the free end of the fresh-water hose
and in the solenoid valve so that they may be cleaned.
To avoid damage caused by leaks or flooding, the tap should
always be closed after the appliance has completed a cycle
and especially during long absences.
Hand-tighten the plastic hose connection locknuts.
For washing machines connected to a hot water supply
and cold water
only. To install the appliance and ensure
correct operation if the household does not have a hot water
supply
, obtain «Connection accessory»
Part no. 5500 001 392 from the Manufacturer's Authorised
Supplier.
Fit the pipes supplied with the washing machine
(see examples):
m
For hot water up to 70 ºC, coupling
.
m
For cold water, coupling
.
