Bosch DX4020-EXP, Руководство по установке

Страница: 9 / 16

DX4020-EXP | Installation Guide | 6. IP Programming EN | 9
Bosch Security Sys | 8/04 | F01U002192B
6.4.2 ARP Command Usage
1. Open a DOS window from the Start menu by
selecting Start
Run.
2. At the Run dialog box, type COMMAND and
click
OK .
A DOS window appears.
3. Type the following at the DOS command line:
arp –s 172.17.10.70 00-20-4a-12-04-
0e
[ENTER]
172.17.10.70 would be the example IP address
given from the Network Administrator and 00-20-
4a-12-04-0e would be the example MAC hardware
address from DX4020.
If following your command the computer responds
with a prompt (as shown to the right) then the
address was accepted.
There is no indication that the operation is
performed properly. The absence of an
error message is your indication that the
function was correct.
4. Verify that the IP address was correctly entered
into the ARP table by typing:
arp -g
[ENTER]
Figure 15: arp -g
This shows the Internet address (IP ADDRESS)
and the corresponding Physical Address (MAC
hardware address). The third line of the table in
Figure 15 shows that the arp contains a MAC
address of 00-20-4a-51-19-8c temporarily linked to
IP address 172.17.10.70.
The network uses this table to identify devices and
route signals. The number of devices and other
“types,” like “dynamic,” depends on the network
and the number and type of devices that this PC
has corresponded with. You must identify the
MAC address of the device you are installing and
verify that it now has an IP address linked to it.
6.5 Using Telnet to Finish the
Configuration
If you are using Windows 95/98, see Section 6.5.1 Using
Windows 95/98 Telnet.
If you are using Windows 2000/XP, see Section 6.5.2
Using Windows 2000/XP Telnet.
6.5.1 Using Windows 95/98 Telnet
1. Open a DOS window from the Start menu by
selecting
Start Run .
2. At the Run dialog box,
telnet
[ENTER].
The Telnet application starts.
3. Select Connect Remote System...
The Connect window displays.
4. Type the IP address of the DX4020 (this is the IP
address that was assigned to the DX4020 in the
previous section) in the Host Name field.
In this example, the IP address is 172.17.10.70.
Type
1
into the Port field and leave the TermType
field at
vt100
.