Bosch DWK068G60, Инструкция по эксплуатации, Страница: 7 / 12

7
Switching over the display for circulating-air mode
For air recirculation, the electronic control display must be
switched over accordingly:
1.
Check whether the extractor hood is connected and switched
off.
2.
Press and hold the 3 button until the # button flashes twice.
The electronic control is switched over to air recirculation.
Switching over the display for circulating-air mode
1.
Check whether the extractor hood is connected and switched
off.
2.
Press the 3 button until the
#
button flashes once.
The electronic control is switched over to air extraction.
Cleaning protection
The appliance is equipped with a cleaning protection function.
When this function is activated, the control panel can be
cleaned without changing the settings.
Switching on
Press and hold the
#
button.
All the buttons on the control panel flash one after the other.
Cleaning protection is switched on.
Switching off
Press and hold the # button until the buttons on the control
panel no longer flash.
Cleaning protection is switched off.
Cleaning and maintenance
:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
Cleaning agents
Observe the information in the table to ensure that the different
surfaces are not damaged by using the wrong type of cleaning
agent. Do not use
■
harsh or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.
Area Cleaning agents
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth.
Clean stainless steel surfaces in the
direction of the grain only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.
Apply a very thin layer of the cleaning
product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and
dry with a soft cloth/towel.
Do not use any stainless steel clean-
ers.
Aluminium and
plastic
Glass cleaner:
Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Operating controls Hot soapy water:
Clean using a damp dish cloth and
dry with a soft cloth.
Risk of damage to the electronics
from penetrating moisture. Never
clean operator controls with a wet
cloth.
Do not use any stainless steel clean-
ers.