en
Operating modes
6
Ç
Operating modes
Operating modes
Exhaust air mode
Note:
The air must not be discharged into a flue that is
used for exhausting fumes from appliances burning gas
or other fuels (not applicable to appliances that only
discharge the air back into the room).
■
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
■
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
Air recirculation
Note:
To bind odours in air recirculation mode, you
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or from
the Online Shop.
1
Operating the appliance
Operating the appliance
Note:
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel
Switching the appliance on and off
Switching on the appliance
Press button 0/1.
The extractor hood starts at fan setting 1.
Selecting the fan setting
Press the 2 or 3 button to set the corresponding fan
setting.
Switching off the appliance
Press the button for the selected fan level again.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Switching on
Press and hold the 3 button for approx. two seconds.
Note:
After 6 minutes, the extractor hood automatically
switches back to the fan setting that was set
beforehand.
Switching off
Press button 1, 2 or 3.
The intensive mode ends.
Lighting
The lighting can be switched on and off independently
of the ventilation.
Press the
B
button.
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter, and is conveyed back into
the kitchen.
Explanation
0/1
Switches the fan on/off
2
Switches on fan setting 2
3
Switches on fan setting 3
B
Switches the lighting on/off
