Basic operation
en
7
6.6 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press
a
The fan run-on starts at fan setting 1.
a
The appliance switches off automatically after ap-
prox. 10 minutes.
6.7 Switching off the fan run-on
▶
Press
6.8 Switching on automatic mode
1
The optimum fan setting is set automatically using a
sensor.
▶
Press .
6.9 Switching off automatic mode
1
▶
Press , or .
a
The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a
Automatic mode runs for a maximum of four hours.
6.10 Sensor control
1
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡
Factory setting: 3
¡
Lowest setting: 1
¡
Highest setting: 5
6.11 Setting the sensor control
Requirement:
The appliance is switched off.
1.
Press and hold .
a
The setting is displayed after approx. one second.
2.
Press , , ,
or
to change the setting.
3.
Release to save the setting.
6.12 Resetting the saturation
indicator_variant 1
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡
After the appliance has been switched off, and 1
appears on the display for the grease filter.
¡
After the appliance has been switched off, and 2
appears on the display for the odour filter.
▶
Press .
a
The saturation indicator is reset.
6.13 Resetting the saturation
indicator_variant 2
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡
After the appliance has been switched off, and 1
appears on the display for the grease filter.
¡
After the appliance has been switched off, and 1
appears on the display for the odour filter.
1.
To reset the saturation indicator for the grease filter,
press .
2.
To reset the saturation indicator for the odour filter,
press .
a
The saturation indicator is reset.
6.14 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement:
The appliance is switched off.
1.
Press and hold
.
‒
To set circulating-air mode (non-regenerative fil-
ter), press .
‒
To set circulating-air mode (regenerative filter),
press .
‒
To set air extraction mode, press .
2.
Release
to save the setting.
6.15 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press .
6.16 Setting the brightness
▶
Press and hold until the required brightness is
reached.
6.17 Switching on the audible signal
Requirement:
The appliance is switched off.
▶
Press and hold and at the same time for ap-
prox. three seconds until a signal sounds.
6.18 Switching off the signal tone
Requirement:
The appliance is switched off.
▶
Press and hold and at the same time for ap-
prox. 3 seconds.
a
A signal tone will sound.
1
Depending on the appliance specifications
