Installation instructions
en
19
6.
Position the appliance on the scissor lift table so
that the appliance is on the frame.
Do not place the appliance on the grease filters as
these could be damaged.
7.
Leave a gap of at least 700 mm between the hob
and the lower edge of the appliance.
When securing cables, ensure that the maximum
distance between the frame cover and the top edge
of the appliance is 1.20 m.
Connecting the appliance
1.
Pull the protective tube over the on-site cable.
Shorten the protective tube if necessary.
2.
Insert the on-site cable into the terminal plug.
L
N
3.
Thread the 4 cables into the lock nuts.
To avoid damaging the appliance's limit switch, do
not insert the lock nuts into the openings.
4.
To protect against scratches, position a spacer on
the appliance and place the frame cover on top of
it.
5.
Thread the cables through the openings of the
frame cover.
6. ATTENTION!
There is a risk of damage to the appliance if the
cable is coiled up.
▶
Always secure the cable firmly using the strain
relief so that it does not coil up fully in the appli-
ance.
Thread the cable on the appliance through the
opening in the frame cover and use the strain relief
supplied to secure it.
7.
Undo the strain relief on the cable on the appliance
and pull out the cable.
8.
Remove the strain relief fitted at the factory.
Put the strain relief to one side.
Содержание DRH18LT65
Страница 23: ......
