Bosch DKE 93 Series, Инструкция по эксплуатации

Страница: 6 / 16

6
Replacing the light bulbs Cleaning and care
Disconnect the hood from the electricity
supply by pulling out the AC plug or
switching it off at the fuse box.
❑
At the same time as you clean the
grease filters, clean off any grease from
all accessible parts of the housing.
This significantly reduces the fire hazard
and ensures that the hood performs as
effectively as possible.
❑
Use a hot detergent solution or a mild
window cleaner to clean the canopy of
the hood.
❑
Do not scrape off any dirt that has dried
on but loosen it up with a damp cloth.
❑
Do not use abrasive cleaning agents or
sponges that could cause scratches.
❑
Note: Do not use alcohol (spirit) on
plastic parts, otherwise the surface may
lose its glass.
Caution: Ensure that the kitchen is
adequately ventilated.
Clean the sliding switch with a soft,
damp cloth (mild detergent solution) only.
Do not use stainless steel polish on the
sliding switch.
Stainless steel surfaces:
❑
Use a mild non-abrasive stainless steel
cleaner.
❑
Clean the surface in the same direction
as it has been ground and polished.
Do not use any of the following to clean
stainless steel surfaces: abrasive sponges,
cleaning agents containing sand, soda,
acid or chloride!
1. Switch off the hood and pull out the
mains plug or switch off the
electricity supply at the fuse box.
2. Remove the grease filters (see Filters and
Maintenance).
3. Press down the bulb cover and
disconnect from the light strip. Fig 2.
4. Replace the light bulb (commercially
available candle bulbs, max. 40 watt,
E12 base). Fig. 3.
5. Attach the lamp cover again.
6. Re-insert the grease filters.
7. Plug the appliance into the mains or
switch it on at the fuse box.
If you encounter a problem
If you have any questions or if a fault
occurs, please call Customer Service:
1-800-735-4328
When you call, please quote the following:
E-Nr. FD
Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.