en
Installation instructions
14
2.
Use the drill jig to mark where the holes are to be
drilled and drill the holes.
3.
Press in the wall plugs flush with the wall.
4.
Screw the two screws into the upper two holes, but
do not screw them in completely.
5.
For operation in air extraction mode, create the
opening for the exhaust pipe in the base of the cab-
inet.
6.
Remove the grease filters.
"Removing the grease filter", Page 7
7.
Hook the appliance into the upper screws.
8.
Align the appliance horizontally.
9.
Screw the upper screws in fully.
10.
Screw in the safety screw tightly.
11.
Fit the grease filters.
To avoid causing damage, do not bend the grease
filters.
Establishing the exhaust air connection
You can install the exhaust pipe on the air-pipe con-
nector on the upper side of the appliance.
1.
Secure the exhaust pipe to the air pipe connector.
2.
Establish the connection to the exhaust air opening.
3.
Seal the joints.
Connecting to the power supply
1.
Insert the mains plug into the protective contact
socket.
2.
If a fixed connection is required, follow the instruc-
tions in the section
"Instructions for the electrical connection",
Removing the appliance
1.
Disconnect the appliance from the power supply.
2.
Loosen the exhaust pipe.
3.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
4.
Loosen the screw connection with the fitted unit.
5.
Remove the appliance.
