en
Installation instructions
18
2.
Pull the cable connection into the strain relief and
remove the transport lock .
3.
Note:
To ensure that the appliance is not yet fully in-
serted into the cut-out, place a slat below the short
side of the appliance in each case.
Insert the appliance into the cut-out in the worktop
from above.
Insert the appliance evenly so that it is not tilted.
4.
Mark the cut-out for the pipework:
‒
Attach the exhaust air hose for the fan box to the
connector.
‒
Slide the fan box into the guide and tighten this
with a screw.
‒
Mark the position of the pipework on the bottom
of the unit.
‒
Undo the screw and remove the fan box again.
5.
Saw out the cut-out for the pipework.
6.
Slide the fan box into the guide, connect the pipe-
work and screw the fan box tightly back in place.
7.
Support the appliance from below and remove the
slats.
8.
Insert the appliance fully in the cut-out.
9.
Align the rails to the bottom and attach to the
side .
10.
Screw the rails onto the bottom of the unit.
11.
Screw in the screw from below and tighten the nut.
