CCU |
User Manual
10 |
20
Robert Bosch Engineering and Business Solutions Private Limited | September 19, 2020
10
Device 3D Model
Figure 2 3D model of the picture
11
Installation
11.1
Installation of Cable Harness
1.
Suitable protective measures against electrostatic discharges are to be taken for persons and tools. In particular,
CCU connector pins are not supposed to be touched.
2.
Liquids and other media are not allowed to come in contact with the connectivity unit connector and its pins.
3.
Plug the Cable harness cable into the CCU. Check the PIN numbers on the connector of the connecting cable.
4.
Make sure that it is connected to the same pin slots on the device side connector. Lock the connector.
5.
For a secure connection, the interlocking mechanism of the connector must not be damaged and must be in a
completely closed state.
6.
It must be ensured that the connector from the wiring harness side is disconnected only in dry and clean
conditions.
7.
Connection and disconnection procedure must be done in a particular sequence as given below:
•
Connection sequence during installation
a.
Connect Antenna cables
b.
Connect main connector
•
Disconnection sequence
a.
Disconnect main connector
b.
Disconnect Antenna cables
WARNING:
Mismatch of the sequence may damage the connector
NOTE:
Un-used connectors (either Antenna Ports or Wired Connectors) must be closed appropriately to meet the
specified IP rating of the product.