Bosch Concept 7400, Руководство пользователя

Страница: 7 / 24

7
Four rubber feet
Four rubber feet with formed suction cups
provide the ultimate in stability, while also
serving to isolate the power unit from the
hard surface to minimize noise and
vibration. Need clean smooth surface, see
figure 2h.
Getting Started
The operation of your Bosch Concept Series
Kitchen Machine is summarized below.
Specific instructions for using each of the
attachments, provided with Bosch Concept
7400 Kitchen Machine follow this summary.
Please read the specific instructions
thoroughly before using that attachment,
paying particular attention to the
IMPORTANT SAFEGUARDS and
WARNINGS provided.
1. Place power unit on suitable work
surface.
Before using the machine with any of
the attachments, the power unit should
be placed on a suitable work surface.
The surface should be sturdy, smooth
and clean; make sure that there is no
flour or oil on the surface. A clean
smooth surface will provide the best
footing for the suction cup feet on
the power unit and will limit slipping
and/or “walking.”
2. Plug power unit into power supply.
Unwind the power unit’s cord to
appropriate length and plug it into
a convenient nearby receptacle.
3. Remove motor drive cover.
Remove motor drive cover from mono-
drive.
4. Select the attachment to be used.
Select attachment you wish to use
and place on power unit. See specific
instructions for attachment selected.
Specific instructions are located on
pages listed below:
Attachment Pages
Mixing bowl w/dough hook ....... 9
–
11
Mixing bowl w/twin whisks ....... 11
–
14
Blender ..................................... 15
–
17
Table 1.
5. Operate unit
Once the attachment is in place, the
power unit may be operated. The
power may be manually turned on and
off using the rotary switch or operating
time may be controlled using the timer.
Using the timer
The operation of the power unit can
be set to turn off automatically after a
set time (maximum on time is 30
minutes). The length of time of
operation may be selected with the
appliance either already on and
running, or with rotary switch in Off,
“O/Off,” position; power unit must,
however, be plugged in.
To use timer function:
1. Turn on the timer function by
depressing the “time on” button,
see figure 2b. The display will show
minutes and seconds separated by
a colon. The initial display will be
“00:00” with the separating colon
flashing.
2. Select the operating time desired
by pressing the “+” button to
increase the time in 10-second
increments or the “-” button to
decrease the time in 10-second
increments.
Holding either button down for more
than 2 seconds will cause the time
to increase or decrease rapidly.
Also, if the running time desired is
close to 30 minutes, the timer can
quickly be set to 30 minutes by