Bosch BULLS 650-185, Руководство по эксплуатации

Страница: 86 / 238

85
Operation
6.5.6.2 Setting the quill stem
Only applies to
ebikes
with this equipment
In the case of a quill stem, the stem and fork
steerer form a permanently interconnected
component, which is clamped in the fork steerer.
The stem and shaft must be replaced together.
Figure 82: Adjusting the quill stem height
1 Undo screw.
2 Pull quill stem out.
3 Tighten screw.
6.5.6.3 Adjusting the
threadless
stem
Only applies to
ebikes
with this equipment
In the case of an
threadless
stem, the stem is
placed directly on the fork steerer, which
protrudes over the frame.
Figure 83: Raising the Ahead stem by fitting spacer rings
The handlebar height is adjusted once during
production using spacer rings. The part of the fork
steerer protruding is then cut off. The handlebar
stem can then no longer be raised.