6 |
Bosch Buderus SSB255 | SSB399 | SSB512 Boilers
Control Operations Guide
03.2018
|
Bosch Thermotechnology Corp.
Data subject to change
3 Heating Modes
3.1 Central heating (CH) mode
There are 6 onboard CH Mode settings which may be selected with the SSB Boiler.
1.
CH Mode = “0” [default mode]
Setpoint control of the boiler using dry
contacts (TT)
2.
CH Mode = “1”
Outdoor Reset using ON/OFF control of the boiler using dry
contacts (TT)
3.
CH Mode = “2”
Full Outdoor reset with no heat demand
4.
CH Mode = “3”
Permanent Setpoint Demand
5.
CH Mode = “4”
Analog control (0-10Vdc) of set point temperature
6.
CH Mode = “5”
Analog control (0-10Vdc) of Boiler Power (%)
Central Heating Mode 0 [default mode]
(Setpoint control of the boiler using dry contacts #11 and #12)
CH Mode “0”
- Boiler demand is generated thru a call for heat on low voltage contacts
#11 and #12 (dry contacts only). The Boiler will then target a temperature equal to
“CH Setpoint”
(par.#3) at the Supply Temperature Sensor. If Temperature exceeds
the target Setpoint temperature by
“CH Hysteresis”
(par.#7) the burner will shut off
until the Supply Temperature Sensor drops the value of “CH Hysteresis” below the
target Setpoint Temperature.
Example:
If “CH Setpoint” is set for 140°F and CH Hysteresis is set for 10°F and there is a call
for heat on #11 and #12 the burner will start when the Boiler Supply Temperature
(System Supply Temperature sensor for cascade) reads a temperture of 130°F or less
and will remain operating until the call for heat is satisifi ed or until the sensor reads
a temperature of 150°F or greater. As long as the call for heat remains the Boiler and
CH Pump contacts will remain energized. The Burner will remain off until temperature
falls to 130°F.
Central Heating
(CH) Mode
Description
Set these Parameters
Parameter #
Description
Default
Range
CH Mode = “0”
Setpoint control using dry
contacts (TT)
3
CH Setpoint
176°F
68 - 194°F
4
System pump overrun
300 sec.
0 – 900 sec.
5
Boiler pump overrun
300 sec.
0 – 900 sec.
7
CH Hysteresis
5.4°F
0 - 36°F
9
Anti-cycle period
180 sec.
10 – 900 sec.
10
Anti-cycle Temp Diff
12.6°F
0 - 36°F
23
Design Supply Min
68°F
39.2 – 179.6°F
24
Design Supply Max.
194°F
80.6 - 194°F
Table 2
