10
Required accessories and tools
Supplied accessories
–
Installation instructions
–
Operating instructions
–
Installation kit
Optional accessories
Extreme Combination Side-by-Side Heating kit
If the gap between the appliances is less than 6" (160 mm).
Other required accessories from
specialist outlets
Ice maker installation kit
1
/
4
" OD copper line
For connecting appliances which require water, e.g. for an
ice maker.
Maximum outer diameter of the water pipe
(without fittings):
13
/
32
" (10 mm).
Tools
–
Cordless screwdriver T20
–
Torx screwdriver T20
–
Torx bit T20 + magnetic holder
–
5
/
16
" (8 mm) hex nut driver
–
Wood drills in different sizes
–
Open end wrench
1
/
2
" (SW 13 mm)
–
Multigrip pliers
–
Adjustable wrench
–
Cutter with adjustable blade
–
Metal tape measure
–
Square
–
Spirit level length 2' (60 cm) and 4' (1,2 m)
–
Marking-out level, length at least 4' (1.2 m) for individual
appliances or 7' (2.0 m) for Side-by-Side installation
Other
–
Stepladder
–
Dolly, hand truck
–
Hammer drill for drilling holes in wall or floor
–
Bits according suitable for material and in different sizes
–
Wooden beam (cross section min. 3" x 4"
(75 x 100 mm²) as an alternative tilt protection,
length according to the width of the installation cavity
–
Wooden screws in different sizes
–
Thin (max.
1
/
16
" (1.5 mm)), suitable material to protect
the floor from damage (e.g. lino)
–
Suitable material for covering and protecting furniture
(e.g. protective sheets)
–
Adhesive tape
NOTE
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
