FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Configuration | en
75
Bosch Sicherheitssysteme GmbH
User Guide
2020-07 | 3.0 | F.01U.378.877
18
Configuration
This chapter contains information about the following points:
–
Physical node address (PNA/RSN), page 75
–
–
–
–
–
–
18.1
Menu overview
Configuration
->
Set Physical Node
Address (PNA/RSN)
Set groups
Detector sensitivity
Operator
Rename elements
Overview
Network services
About ...
18.2
Physical node address (PNA/RSN)
The physical node address (RSN) of the panel is set in the panel firmware when switching on
the panel for the first time, there are no mechanical rotary switches. It must be identical with
the physical node address configured in the programming software. After a change of the
physical node address (RSN), a reboot of the panel is required.
To change the physical node address enter a number between 1 and 64. Choose
OK and
reboot
to make the change effective.
18.3
Group setting
Different kind of groups can be created using the FSP-5000-RPS programming software:
Bypass, isolate and walktest groups and input / output groups.
Each group can consist of one or more element(s).
Input groups consist of several detectors and/or logical zones; Output groups consist of
signaling devices and transmission devices. Specify which input group activates which output
group by using the programming software.
You can use the panel controller to carry out the following:
–
Adding elements to or removing elements from groups.
–
Renaming groups.
18.3.1
Adding or deleting
In order to add elements to a group or remove elements from it:
1.
In the start menu, select
Configuration
2.
Set groups
3.
Select the required type of group.
Two different lists are displayed.
4.
Select a list, e.g.
By description
.
A list of the various input groups is displayed.
5.
Select the list field you require.
The list field is marked.
You can select various options:
