Bosch AutoDome Junior HD VJR Series, Руководство по эксплуатации

Страница: 16 / 114

Installing a Surface Mount
Description
This chapter details how to mount the AutoDome Junior to a hard surface. The AutoDome
Junior is also suitable for wall (Installing a Wall Mount, page 22), recess (Installing a Recessed
Mount, page 29), and pipe mounting (Installing a Pipe Mount, page 30). For specific
directions on mounting the unit, see the manual that came with your mount.
Notice!
The image sensors in modern cameras are highly sensitive and require special care for proper
performance and extended lifetime. Follow the guidelines for optimum results with your
camera:
Do not expose to direct sunlight or bright spotlights in operating and nonoperating
conditions.
Avoid bright lights in the field of view of the camera. Bright lights cause a “smearing” effect,
which is visible as white lines above and below the highlight. Prolonged exposure to bright
lights may cause bleaching of the sensor's color filters. This will be visible as colored spots in
the picture and is irreversible.
Additional Tools Required
– Appropriate straight slot screwdrivers
– No. 2 Phillips screwdriver
– Appropriate tool for cutting a hole in drywall or ceiling tile (if applicable)
– 4 in. x 4 in. Junction box with 90 mm (3.54 in.) mount holes (indoor installation)
– One (1) ground
– T-10 Torx wrench
Preparing the Surface Mount for an Indoor Installation
The following instructions detail the preparation necessary to prepare the surface and the
steps to install a Surface Mount.
4
Determine a secure location for the surface mount dome.
ø
175.0
(6.89)
166.9
(6.57)
R64.2
(2.53)
Figure 4.1: Indoor Surface Mount Dimensions
4
4.1
4.1.1
4.1.2
16 en | Installing a Surface Mount AutoDome Junior HD Series
2014.11 | 6.1 | F.01U.275.803 Operation Manual Bosch Security Systems, Inc.