Bosch AUTODOME IP starlight 5000i IR, Руководство пользователя

Страница: 57 / 72

AUTODOME IP starlight 5000i IR Network | en 57
Bosch Security Systems User Manual 2019.11 | 1.2 |
Host name
Enter the host name registered on DynDNS.org for the camera here.
User name
Enter the user name you registered at DynDNS.org here.
Password
Enter the password you registered at DynDNS.org here.
Force registration now
You can force the registration by transferring the IP address to the DynDNS server. Entries
that change frequently are not provided in the Domain Name System. It is a good idea to force
the registration when you are setting up the device for the first time. Only use this function
when necessary and no more than once a day, to avoid the possibility of being blocked by the
service provider. To transfer the IP address of the camera, click the
Register button.
Status
The status of the DynDNS function is displayed here for information purposes. You cannot
change any of these settings.
9.4 Advanced
The settings on this page are used to implement advanced settings for the network.
Operation
The operation mode determines how the camera communicates with Cloud-based Security
and Services.
–
Select Auto to allow the camera to poll the server a few times; if no contact is made, it
stops polling.
– Select On to constantly poll the server.
– Select Off to block polling.
Cloud state
This field identifies any cloud-based services with which the camera communicates.
–
If you have registered the device on a cloud-based service such as Bosch Remote Portal,
then this field identifies this fact (“
Registered on Bosch Remote Portal ”).
Note : The button ( Connect to Bosch Remote Portal ) to connect to the device with that
service is active.
– If you have not registered the device, then the message, “ Not running . (Automatic IP
assignment not active) “ appears.
Note : The button ( Connect to Bosch Remote Portal ) to connect to the device with that
service is not active.
Stratocast
Enter the Stratocast Registration code to connect with the Genetec’s Stratocast cloud.
Click Register to activate the account.
Authentication
If a RADIUS server is employed in the network for managing access rights, authentication must
be activated here to allow communication with the unit. The RADIUS server must also contain
the corresponding data.
To configure the unit, you must connect the camera directly to a computer using a network
cable. This is because communication via the network is not enabled until the
Identity and
Password parameters have been set and successfully authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying the camera.