Bosch AUTODOME 4000 mini, Руководство по установке

Страница: 16 / 36

2. Use the four (4) holes at the end of the Wall Mount as a template to mark the position
where the holes should be drilled to secure the mount.
3. Drill the four (4) holes in the installation location, screws not supplied. Use a minimum
screw length of 10 mm (.39 in.).
4. Drill a fifth hole (maximum of 20 mm) in the center of the four-hole pattern used to
mount the arm.
5. Feed all wires from the camera through the arm using a wire puller tool, and make the
necessary connections.
6. In moist, wet, or outdoor applications, place the flat gasket (item 1, below), between the
surface and Wall Mount, and make sure that the wires go through the gasket into the wall.
7. Secure the mount using four (4) appropriate user-provided fasteners such as Moly or
Toggle bolts.
8. Attach the mounting cap to the arm. In moist, wet, or outdoor applications, make sure
that the thread on the arm is sufficiently taped with Teflon tape before the mounting cap
is attached.
9. Skip to Installing the Camera to the Mounting Cap, page 16, to continue the installation.
Installing the Camera to the Mounting Cap
Use the following instructions to install the camera to the mounting cap.
1.
Remove the dome cover from the camera by loosening the three (3) dome cover
mounting screws.
4.5
16 en | Installing a Wall Mount (AUTODOME 4000) AUTODOME 4000 Mini PTZ Dome
2015.08 | | Wall + Pipe Mounts Installation Manual Bosch Security Systems, Inc.