582819 | REV. A | 07.2018
Bosch Automotive Service Solutions Inc
ADS 325
|
User Manual
| 19 | en
OBDII
Overview
OBDII (also referred to as Generic OBDII) provides
limited engine control and monitors the diagnostic
control network of the vehicle. When a fault in the con-
trol network occurs, a DTC is recorded in the vehicle
computer. This system is not vehicle specific so it is NOT
necessary to select the vehicle to run a generic test.
NOTE: Enhanced OBDII may be selected from the Diagnostics
menu with a vehicle loaded for more specific Mode 6 test informa-
tion.
Diagnostic Functions
May 31, 2018
Connected
Select Vehicle
OBDII
Main Menu
10:33
All Apps
System Settings
See What’s New
Web Browser
Saved Diagnostic Data
ss03106
1. Select OBD-II from the Main Menu screen.
2. Follow the prompts on the screen.
Readiness Monitors
Mode 1 displays available monitor information.
The OBDII system has a series of systems that run self-
tests. These systems or components have to be made
ready by turning on the ignition or manipulating the
system in some other manner. This is called drive cycle.
Each system requires specific vehicle drive cycle and
operating requirements to take place before the monitor
self-check will run. OBDII systems require one monitor
for current systems, or two monitors for older systems,
are ready before testing can begin.
If the system is ready, no further action is required.
If the system is not ready, a drive cycle may need to be
performed for that system.
Use the following procedure to verify the system is ready
to be monitored.
Generic OBDII
10:52
Readiness Mode 1
Misfire Monitor
Monitor Description
Readiness (Mode 1)
A/C System Refrigerant Monitor
EGR System Monitor
Catalyst Monitor
Heated Catalyst Monitor
Status
Data Stream Mode 1
DTCs Modes 3, 4, 7, A
Freeze Frame Mode 2
02 Sensors Mode 5
Use Metric Units
Share
Help
?
May 31, 2018
Connected
Not Supported
Ready
Ready
Ready
Not Supported
ss03107
1. View the readiness table to verify system status.
• Ready: No further action is required.
• Not ready: Further action is required. Drive Cycle
needs to be performed.
• Monitor not supported: Data is not supported on
vehicle.
Readiness Mode Button Definitions
Other
Other Button
Tapping the Other button displays a pop-up link that
takes the user to more buttons.
Help
Help
Selecting Help will open an online user manual.
Use Metric Units
Use Metric Units
Selecting Metric Units will switch from English/Stan-
dard Units to Metric Units
Use English/Standard Units
Use English/Standard Units
Selecting English/Standard Units will switch from
Metric Units to English/Standard Units.
Screen Capture
Screen Capture
Selecting Screen Capture will save a copy of the cur-
rent open screen.
