![background image](http://html.mh-extra.com/html/bosch/3h-2c/3h-2c_installation-and-operation-manual_50750008.webp)
8 |
Bosch 3H/2C Touch-Technology Thermostat
Installation, Operation & Application Manual
08.2016
|
Bosch Thermotechnology Corp.
Data subject to change
5 System setup and con
fi
guration
5.1 Connection to the UPM
The UPM’s ALARM COM terminal should be connected to R on the UPM board
(refer to unit manual for more information), and the ALARM OUT terminal should
be connected to the A terminal on the thermostat. The UPM must be confi gured as
described in Section 5.2.
5.2 Con
fi
guration of the UPM
The ALARM DIP switch on the UPM has to be set to the ON position (“PULSE”).
Simply push the right side of this switch, so it is down on the right side and up on the
left side.
OUTCOM
ALR
DISPLAY
4
3
2
1
LOCKOUT
RESET
ALARM
TEST
4
R
CONT
YES
2
Y
PULSE
NO
UPM
A
RH
RC
C
Y1
W/O/B
G
W2
Y2
AUX
Thermostat Back Plate
Figure 3
5.3 Output chart
Description
1st Cool
2nd
Cool
1st Heat
2nd
Heat
3rd Heat
Heat/Cool
Y1, G
YI, Y2, G
W1, G*
W1, W2, G*
W1, W2,
AUX, G*
Heat Pump
(one compressor, single
stage )
Y1, G, O
Y1, G, O
Y1, G, B
Y1, W2,
G, B
Y1, W2,
AUX, G, B
Heat Pump
(one compressor,
two stage and two
compressor.)
Y1, G, O
Y1, Y2,
G, O
Y1, G, B
Y1, Y2,
G, B
Y1, Y2, W2,
G, B
Emergency Heat
(heat pump only)
N/A
N/A
W2, G
W2, AUX**,
G
N/A
Table 2
* G not on for gas/oil systems
** One compressor only
The thermostat is confi gurable for all systems. The confi guration directly aff ects the
outputs. Use the output chart to correctly confi gure and wire the thermostat to your
system.
5.4 Con
fi
guration and thermostat lock
During Confi guration Mode, certain settings are protected by a numeric code access
screen to prevent unintentional changes that could potentially damage the system or
create a dangerous condition.
Whenever changes are attempted to one of the critical settings, the unlock code
screen will appear:
The unlock code for these critical settings can be found during the power-up
sequence.
The large number (indicated by “98” in the diagram) is the code that will unlock
the desired confi guration setting. The smaller numbers (indicated by “93” and
“82” in the diagram) are codes used to lock and unlock your thermostat to prevent
tampering.
To view the default codes for your thermostat, remove the thermostat from the
sub base and, if using batteries, remove one battery for 10 seconds. Replacing the
batteries or reinstalling thermostat will cause the codes to display for approximately
5 seconds.
Write your
codes here
Thermostat lock code
Figure 4
5.5 Locking & unlocking thermostat
Press
, then
, then
MENU
LOCK
, then
Use
&
to select digit.
Use
&
to set number.
Press
to lock or unlock.